HP ProCurve 5400zl Reference Manual page 278

Command Line Interface Reference Guide
o <name> - Policy name.
o in - Apply the policy in inbound direction.
Next Available Option:
in -- Apply policy on inbound packets.
■
source-lockdown
■ [no] interface [ETHERNET] PORT-LIST ip source-lockdown
Usage: [no] ip source-lockdown [ethernet] <port-list>
Description: Enable/disable IP source lockdown in global configuration mode.
speed-duplex
■ interface [ETHERNET] PORT-LIST speed-duplex < 10-half | 100-half | 10-full | ... >
Usage: speed-duplex <10-half|100-half|10-full|100-full|1000-full|
Description: Define mode of operation for the port(s).
© 2009 Hewlett-Packard Development Company, L.P.
Using the port-list option it can be configured on per-port basis.
auto|auto-10|auto-100|auto-1000|auto-10-100>
This is an Interface context command. It can be called directly
from the interface context or follow the 'interface [ethernet]
PORT-LIST' command.
For 10FL:
- 10-half 10 Mbps, half duplex (default). The port operates
according to the IEEE 802.3/Ethernet standards.
- 10-full 10 Mbps, full duplex. The port simultaneously
receives and transmits data. (The device attached
to the port must support full duplex operation).
For 10/100TX:
Note: Make sure that the device attached to the
port is configured the same as the selection you
make here.
- auto (default) The port automatically selects the
network speed (10 or 100 Mbps), and that data
transfer operation (full or half duplex) between
the switch and another IEEE 802u-compliant device
running the 'Auto Negotiation' protocol.
- 10-half 10 Mbps, half duplex.
- 10-full 10 Mbps, full duplex.
- 100-half 100 Mbps, half duplex.
- 100-full 100 Mbps, full duplex.
- auto-10 Same as 'auto' except that the port speed is fixed
at 10 Mbps. The data transfer operation (full or
half duplex) is auto negotiated.
For 100FX:
- 100-full (default) 100 Mbps, full duplex.
- 100-half 100 Mbps, half duplex.
For 1000T:
- auto (default) The port automatically selects the
(p. 238)
interface
276