HP ProCurve 5400zl Reference Manual page 210

Command Line Interface Reference Guide
all
■
host
■
src-ip
■
dhcp-snooping
■
forbid -- Prevent ports from becoming a member of the current VLAN ([ethernet] PORT-LIST)
■
(p. 234)
igmp-proxy
■
domain-name
■
with the VLAN. (ASCII-STR)
ip -- Configure various IP parameters for the VLAN
■
access-group
■
(p. 214)
direction
■
address
■
dhcp-bootp
■
(p. 230)
ip-addr
■
bootp-gateway
■
DHCP requests
ip-addr
■
forward-protocol
■
udp
■
■
helper-address
■
igmp
■
238)
auto
■
(this is the default behavior) ([ethernet] PORT-LIST)
blocked
■
ports ([ethernet] PORT-LIST)
fastleave
■
forcedfastleave
■
when the port is cascaded ([ethernet] PORT-LIST)
forward
■
specified ports ([ethernet] PORT-LIST)
high-priority-forward
■
IP Multicast groups
querier
■
■
irdp -- Configure ICMP Router Discovery Protocol (IRDP)
■
advert-address
■
for router advertisements
holdtime
■
on this interface
maxadvertinterval
■
sending unsolicited router advertisements
minadvertinterval
■
sending unsolicited router advertisements
preference
■
routers on the same subnet
© 2009 Hewlett-Packard Development Company, L.P.
-- Resets all previously blocked by the connection rate filter
-- Match packets from the specified IP address. (IP-ADDR)
-- Match packets from the specified subnet. (IP-ADDR/mask-LENGTH)
-- (p. 230)
-- Associate an IGMP proxy domain with a VLAN
< END OF PRINTABLE > -- Specify the domain name to associate/disassociate
-- Apply the specified access control list on this VLAN interface (ASCII-STR)
< in | out | connection-rate-filter | ... > --
-- Set IP parameters for communication within an IP network
-- Configure the interface to use DHCP/Bootp server to acquire parameters.
-- Interface IP address/mask. (IP-ADDR/mask-LENGTH)
-- Add or remove the gateway address to be used for stamping incoming
(p. 228)
-- IPv4 address of the BOOTP gateway. (IP-ADDR)
-- Add or remove a UDP server address for the VLAN
-- Add or remove a UDP server address for the VLAN
ip-addr -- IP address of the protocol server. (IP-ADDR)
port-name < dns | ntp | netbios-ns | ... > -- (NUMBER)
■
port-num -- UDP port number of the server. (TCP/UDP-PORT)
■
-- Add or remove a DHCP server IP address for the VLAN (IP-ADDR)
-- Enable/disable/configure IP Multicast Group Protocol (IGMP) feature on a VLAN
-- Instruct the device to monitor incoming multicast traffic on the specified ports
-- Instruct the device to drop incoming multicast packets received on the specified
-- Enables or disables IGMP Fast Leaves ([ethernet] PORT-LIST)
-- When enabled, this feature forces IGMP Fast Leaves to occur even
-- Instruct the device to forward incoming multicast packets received on the
-- Enable/disable the high priority forwarding of traffic for subscribed
(p. 237)
-- Specify querier/non-querier capability for the VLAN
interval < 5 to 300 > -- Sets the interval in seconds between IGMP queries (default:
125) (p. 240)
< multicast | broadcast > -- Specify the destination address to be used
< 4 to 9000 > -- Set the lifetime (in seconds) of the router advertisements sent
(p. 237)
< 4 to 1800 > -- Set the maximum time (in seconds) allowed between
< 3 to 1800 > -- Set the minimum time (in seconds) allowed between
-- The preferability of the router as a default router, relative to the other
(p. 231)
(p. 240)
(p. 227)
(p. 234)
(p. 219)
(p. 249)
(p. 250)
(p. 264)
(p. 219)
(p. 237)
(p. 238)
(p. 231)
(p. 216)
(p. 241)
(p. 241)
(p. 235)
(p. 280)
(p. 241)
(p. 263)
(p. 263)
(p. 225)
(p. 234)
(p. 269)
(p. 246)
interface
(p. 277)
(p. 237)
(p.
(p. 233)
208