HP ProCurve 5400zl Reference Manual page 561

Command Line Interface Reference Guide
Range: < 0 to 16 >
instrumentation
■ show instrumentation
Usage: show instrumentation
Description: Show internal version-dependant counters for debugging.
This data is for factory troubleshooting purposes.
is dependent on which version of code is running.
Data is maintained for the current 5 minutes, hour, and day.
every 5 minutes, hour, or day, averages and min/max values are calculated
and the current interval's data is copied to the previous interval's data.
For example, the previous day's data is updated at midnight local time. The
previous hour's data is updated on the hour.
There are many situations in which data is not yet available, or data is
not maintained.
error condition.
Next Available Options:
monitor
■
cam -- Show internal version-dependant counters for
■
vlan -- Show internal version-dependant counters for debugging for thespecified port or vlan
■
number(p. 603)
port -- Show internal version-dependant counters for debugging for thespecified port or vlan
■
number(p. 577)
resptime
■
for response time
■ show tech instrumentation
Usage: show tech [all|custom|buffers|instrumentation|mesh|route|statistics
Description: Display output of a predefined command sequence used by
interface
■ show ip ospf interface
Usage: show ip ospf interface [IP-ADDR|vlan VLAN-ID]
Description: Show OSPF interfaces' information. Invoked without
Next Available Options:
vlan -- Specify VLAN of the interface for which to show detailed information. (VLAN-ID)
■
if-ip -- Specify IP address of the interface for which to show detailed information. (IP-ADDR)
■
(p. 556)
© 2009 Hewlett-Packard Development Company, L.P.
In this case, an asterisk is displayed.
-- Show latest values for monitored
-- show service response time data for performance sensitive operations registered
measurement(p. 585)
|transceivers|vrrp]
technical support.
parameters shows all OSPF interfaces configured. If the
'IP-ADDR' or the VLAN is specified detailed information
for the interface determined through the parameter is shown.
The data displayed
It is never an
parameters(p. 570)
debugging(p. 536)
show
At the end of
(p. 603)
559