HP ProCurve 5400zl Reference Manual page 299

Command Line Interface Reference Guide
■ 3des-cbc
■ aes192-cbc
■ aes256-cbc
■ rijndael-cbc@lysator.liu.se
■ aes128-ctr
■ aes192-ctr
■ aes256-ctr
connection-rate-filter
■ [no] ip access-list connection-rate-filter
Configure a connection-rate-filter Access Control List.
Next Available Option:
name -- Specify name of Access Control List to configure. (ASCII-STR)
■
default
■ ip ssh port default
Specify that the daemon should listen on the default TCP port (22).
default-gateway
■ [no] ip default-gateway
Usage: [no] ip default-gateway [IP-ADDR]
Description: Configure the IPv4 default gateway address, which will be
Next Available Option:
ipaddr -- IPv4 address of the default gateway. (IP-ADDR)
■
dhcp
■ ip timep dhcp
Use DHCP to acquire Timep server address.
Next Available Option:
interval < 1 to 9999 > -- Specify how often (in minutes) the switch tries to get the current
■
301)
dhcp-bootp
■ ip address dhcp-bootp
Configure the interface to use DHCP/Bootp server to acquire parameters.
© 2009 Hewlett-Packard Development Company, L.P.
used when routing is not enabled on the switch. The IP-ADDR
must be specified if the command is not preceded by 'no'.
Preceding the command with 'no' deletes the default gateway
address.The 'no' form of this command does not take
effect on default gateway address obtained via dhcp.
(p. 304)
(p. 302)
ip
time.(p.
297