HP ProCurve 5400zl Reference Manual page 35

Command Line Interface Reference Guide
Configure how traffic is controlled on non-authenticated ports; in
BOTH directions (ingress+egress) or IN only (ingress).
Supported Values:
■ both -- Exert control in both directions.
■ in -- Exert control on incoming packets.
dhcp-addr
■ aaa port-access web-based dhcp-addr IP-ADDR/MASK-LENGTH
Set the base address / mask for the temporary pool used by DHCP (base address default
is 192.168.0.0, mask default is 24 - 255.255.255.0).
dhcp-lease
■ aaa port-access web-based dhcp-lease < 5 to 25 >
Set the lease length of the IP address issued by DHCP (default 10).
Range: < 5 to 25 >
enable
■ aaa authentication console enable
Configure access to the privileged mode commands.
Next Available Option:
primary
■
control.(p. 44)
■ aaa authentication telnet enable
Configure access to the privileged mode commands.
Next Available Option:
primary
■
control.(p. 44)
■ aaa authentication web enable
Configure access to the privileged mode commands.
Next Available Option:
primary
■
44)
■ aaa authentication ssh enable
Configure access to the privileged mode commands.
Next Available Option:
primary
■
control.(p. 44)
© 2009 Hewlett-Packard Development Company, L.P.
< local | tacacs | radius > -- Specify the primary authentication method for access
< local | tacacs | radius > -- Specify the primary authentication method for access
< local | radius > -- Specify the primary authentication method for access
< local | tacacs | radius | ... > -- Specify the primary authentication method for access
aaa
control.(p.
33