HP ProCurve 5400zl Reference Manual page 558

Command Line Interface Reference Guide
fingerprint
■
icmp
■ show ip icmp
Usage: show ip icmp
Description: Show ICMP Rate Limiting settings.
■ show rate-limit icmp
Show only limits for icmp traffic.
Next Available Options:
port-list
■
detailed
■
if-ip
■ show ip ospf statistics IP-ADDR
Specify IP address of the interface for which to show detailed information.
■ show ip ospf interface IP-ADDR
Specify IP address of the interface for which to show detailed information.
■ show ip rip interface IP-ADDR
Specify IP address of the interface for which to show detailed information.
igmp
■ show igmp
Usage: show igmp [...]
Description: Show global switch IGMP configuration parameters.
Next Available Option:
delayed-flush
■
■ show ip igmp
Usage: show ip igmp [config|group IP-ADDR|VLAN-ID [config]]
Description: Invoked without any parameters, shows per-VLAN IGMP status,
© 2009 Hewlett-Packard Development Company, L.P.
-- Display hexadecimal
-- Specify ports for which information will be shown. ([ethernet] PORT-LIST)
-- Show Inbound Radius Override
To get a list of all possible parameters use 'show igmp ?'.
-- Shows switch-wide IGMP delayed flush
or, if VLANs are disabled displays the global IGMP status.
When followed by the 'config' keyword, shows IGMP global
configuration information. VLAN-ID can be used to get
operational and configuration information for a particular
VLAN, if VLAN support is enabled. The 'group' keyword can be
used to show a list of ports where a particular multicast group
is registered.
hash.(p. 552)
details.(p. 546)
value(p. 545)
show
(p. 578)
556