Command Line Interface Reference Guide
Next Available Options:
auto-summary
■
default-metric
■
distance
■
redistribute
■
into
RIP(p. 485)
restrict
-- Prevent redistribution of routes via
■
rp-address
■ [no] router pim rp-address
Usage: [no] rp-address <IP-ADDR> [GROUP-ADDR/GROUP-MASK] [override]
Description: Statically configure the Rendezvous Point (RP) to accept
Parameters:
o IP-ADDR
o GROUP-ADDR - IP address of multicast group, when combined
o GROUP-MASK - Defines the range of multicast group addresses.
o override
Next Available Option:
IP-ADDR
■
rp-candidate
■ [no] router pim rp-candidate
Usage: rp-candidate [source-ip-vlan <VLAN-ID>]
no rp-candidate [source-ip-vlan <VLAN-ID>]
Description: Configure router to advertise itself as the Candidate
© 2009 Hewlett-Packard Development Company, L.P.
and changes current context to RIP Configuration Context.
Otherwise, the command disables RIP. The command can be
followed by a RIP configuration command. Use 'router rip ?' to
get a list of all possible options.
-- Enable/disable advertisement of summarized
< 1 to 15 > -- Set default metric for imported
< 1 to 255 > -- Set administrative distance for routes learned via
< connected | static | ospf > -- Specify source protocols which will be redistributed
multicast traffic for specified group or range of groups.
If GROUP-ADDR/GROUP-MASK is not specified, the default multicast
group prefix 224.0.0.0/4 (224.0.0.0 240.0.0.0) will be used.
To remove all entries associated with the RP or a specific
entry use 'no' form of the command.
- IP address of the Rendezvous Point.
with GROUP-MASK, gives the group prefix.
- Sets the precedence of statically configured RP higher
than dynamically learned RPs. Not set by default.
-- Specify the IP address of the static RP. (IP-ADDR)
[group-prefix <GROUP-ADDR/GROUP-MASK>]
[hold-time <30-255>]
[priority <0-255>]
[group-prefix <GROUP-ADDR/GROUP-MASK>]
Rendezvous Point (Candidate-RP) to the Bootstrap Router (BSR).
When enabling router to be a Candidate-RP the VLAN ID must
be specified, which IP address will be advertised as a
Candidate-RP's IP address. PIM-SM must be enabled on the VLAN.
If GROUP-ADDR/GROUP-MASK is not specified the router will be a
Candidate-RP for all multicast groups. Use 'no' form of this
routes(p. 476)
routes(p. 478)
RIP(p. 485)
(p. 481)
router
RIP(p. 479)
487