Member - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Usage You must first enable DEI for this configuration to take effect.
Information
Related dei enable
Commands

member

Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible command in its configuration.
S4810
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface
Defaults Not configured.
Command CONF-IF-VLAN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1694
Introduced on the S6000.
Instroduces on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
– Make packets eligible for dropping based on their DEI value.
Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabyte Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
VLAN Stacking