Ntp Server - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.4.1.0
Version 8.3.7.0
pre-Version
6.1.1.0

ntp server

Configure an NTP time-serving host.
S4810
Syntax
ntp server [vrf vrf-name] {hostname | ipv4-address | ipv6-
address} [key keyid] [prefer] [version number]
Parameters
vrf vrf-name
ipv4-address |
ipv6-address
hostname
key keyid
prefer
version number
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1654
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for IPv6 multicast addresses.
Introduced on the S4810.
Introduced on the E-Series.
(Optional) Enter the keyword vrf and then the name of the
VRF to configure a NTP time-serving host corresponding to
that VRF.
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X).
Enter the hostname of the server.
(OPTIONAL) Enter the keyword key and a number as the
NTP peer key. The range is from 1 to 4294967295.
(OPTIONAL) Enter the keyword prefer to indicate that this
peer has priority over other servers.
(OPTIONAL) Enter the keyword version and a number to
correspond to the NTP version used on the server. The range
is from 1 to 3.
System Time and Date