Ntp Broadcast Client - Dell S4810 Reference Manual

ntp broadcast client

Set up the interface to receive NTP broadcasts from an NTP server.
S4810
Syntax
ntp broadcast client
To disable broadcast, use the no ntp broadcast client command.
Defaults Disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
ntp disable
Prevent an interface from receiving NTP packets.
S4810
Syntax
ntp disable
To re-enable NTP on an interface, use the no ntp disable command.
Defaults Disabled (that is, if you configure an NTP host, all interfaces receive NTP packets)
Command INTERFACE
Modes
1652
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
System Time and Date