Uplink-State-Group - Dell S4810 Reference Manual

13/5(Up) Te 13/6(Up)
Uplink State Group
Upstream Interfaces
Downstream Interfaces : Te 13/2(Dis) Te 13/4(Dis) Te
13/11(Dis) Te 13/12(Dis) Te 13/13(Dis) Te 13/14(Dis) Te
13/15(Dis)
Uplink State Group
Upstream Interfaces
Downstream Interfaces :
Uplink State Group
Upstream Interfaces
Downstream Interfaces :
Uplink State Group
Upstream Interfaces
Downstream Interfaces : Gi 0/40(Dwn)
Related
•
Commands
•

uplink-state-group

Create an uplink-state group and enable the tracking of upstream links on a switch/ router.
S4810
Syntax
uplink-state-group group-id
To delete an uplink-state group, enter the no uplink-state-group group-id
command.
Parameters
group-id
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
1686
show running-config uplink-state-group
of one or more uplink-state groups.
uplink-state-group — create an uplink-state group and enables the tracking of
upstream links.
Enter the ID number of an uplink-state group. The range is
from 1 to 16.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
: 5 Status: Enabled, Down
: Gi 0/0(Dwn) Gi 0/3(Dwn) Gi 0/5(Dwn)
: 6 Status: Enabled, Up
:
: 7 Status: Enabled, Up
:
: 16 Status: Disabled, Up
: Gi 0/41(Dwn) Po 8(Dwn)
— displays the current configuration
Uplink Failure Detection (UFD)