Honda 2004 Odyssey Service Manual page 2230

'02 Model
DTC 11-3: Short to Another Wire or
Decreased Resistance in Driver's Side Airbag
Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the left side wire harness 2P connector
(A) from the driver's side airbag (B).
A
07XAZ-S1A0200
5. Connect the special tool (2
side wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
B
07SAZ-TB4011A
connector) to the left
8. Read the DTC (see page 23-35).
Is DT C 11-3 indicated?
YES Go to step 9.
NO Short to another wire in the driver's side
airbag inflator; replace the driver's side airbag (see
page 23-372).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's side airbag 2P
connector (A).
A
11. Disconnect the special tool from the left side wire
harness 2P connector.
(cont'd)
23-165