Honda 2004 Odyssey Service Manual page 2151

SRS
DTC Troubleshooting (cont'd)
'99-01 Models
DTC 3-4: Short to Power in Driver's Seat Belt
Tensioner
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Disconnect the battery negative cable, and wait for
3 minutes.
4. Disconnect the driver's seat belt tensioner 2P
connector from the left side wire harness 2P
connector (A).
A
5. Connect the special tool (2
side wire harness 2P connector.
23-86
07TAZ-SZ5011A
07SAZ-TB4011A
connector) to the left
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-35).
Is DT C 3-4 indicated?
YES Go to step 9.
NO Short to power in the driver's seat belt
tensioner; replace the driver's seat belt (see page
23-4).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the SRS main harness 2P connector
C551 from the left side wire harness 2P connector (A).
A
07SAZ-TB4011A
11. Connect the special tool (2
main harness 2P connector.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is DT C 3-4 indicated?
YES Go to step 15.
NO Short to power in left side wire harness;
replace the left side wire harness.
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
C551
07TAZ-SZ5011A
connector) to the SRS