Honda 2004 Odyssey Service Manual page 2108

10. Remove the weight from the front passenger's seat.
11. Drive the vehicle, accelerate to 20 mph (36 km/hr),
then stop on level ground.
12. From the inspection menu, select ''SEAT OUTPUT
CHK.'' The weight (T0) of the front passenger's seat
is recorded by the HDS.
• If the reading on the tester (T0) is
kg) or less, go to step 13.
• If the reading on the tester (T0) is mean than
6.6 lbs ( 3.0 kg), repeat steps 3 9.
13. Measure and note the prepare weight (M1) again
with a weight scale.
14. Place the weight on the front passenger's seat.
15. Drive the vehicle, accelerate to 20 mph (36 km/hr),
then stop on level ground.
16. From the inspection menu, select ''SEAT OUTPUT
CHK.'' The weight (T1) of the front passenger's seat
is recorded by the HDS.
17. Calculate the variance between the weight
measured by the weight scale and the tester, by
using the formula provided.
Variance = (T1) (M1)
T1: Weight measure by the tester with the weight
M1: Weight measure by the weight scale.
6.6 lbs ( 3.0
• If the variance is
• If the variance is more than
NOTE: If the front passenger's weight sensors were
not replaced before this step, replace them before
going to the next step.
18. Turn the ignition switch OFF, and disconnect the
HDS from the DLC.
8.6 lbs (3.9 kg)
on the seat
8.6 lbs ( 3.9 kg) or less,
calibration is complete. go to step 18.
replace the front passenger's weight sensors (if
they were not replaced before this step), and
repeat this procedure from the beginning.
8.6 lbs ( 3.9 kg),
(cont'd)
23-43