Honda 2004 Odyssey Service Manual page 2367

SRS
DTC Troubleshooting (cont'd)
14. Disconnect dashboard wire harness A 21P
connector C505 from the right side wire harness.
15. Turn the ignition switch ON (II).
16. Check for voltage between the No. 4 terminal of
dashboard wire harness A 21P connector C505 and
body ground. There should be battery voltage.
DASHBOARD WIRE HARNESS A 21P CONNECTOR C505
YEL/GRN
Wire side of female terminals
Is there battery voltage?
YES Open in the YEL/GRN wire of the right side
wire harness; replace the right side wire harness.
NO Open in the YEL/GRN wire of the dashboard
wire harness; replace the faulty harness.
23-302
17. Turn the ignition switch OFF.
18. Check resistance between the No. 6 terminal of the
right side wire harness 6P connector C and body
ground. There should be 0 1.0
RIGHT SIDE WIRE HARNESS 6P CONNECTOR C
C505
Is the resistance as specif ied?
YES Go to step 19.
NO Open in the BLK wire of the right side wire
harness; check for poor ground connection at G851.
If the connection is OK, replace the right side wire
harness.
19. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
20. Disconnect both seat belt tensioner 2P connectors
(A).
.
BLK
Wire side of female terminals
A