Honda 2004 Odyssey Service Manual page 2360

'03-04 Models
DTC 71-1x (71-10 to 71-19, 71-1A to 71-1F):
Open in the Driver's Seat Position Sensor
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Check the connection between the driver's seat
wire harness 2P connector (with power seat) or
driver's seat position sensor subharness 2P
connector (without power seat) and the driver's
seat position sensor.
4. Erase the DTC memory.
5. Read the DTC (see page 23-38).
Is DT C 7 1-1x indicated?
YES Go to step 6.
NO Repair the poor connections and retest. If DTC
71-1x is still present, go to step 6.
6. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
7. Disconnect the driver's airbag 4P connector (A)
from the cable reel.
A
8. Disconnect the driver's seat wire harness 2P
connector (with power seat) or driver's seat
position sensor subharness 2P connector (without
power seat) from the driver's seat position sensor
(A).
9. Connect the special tool (jumper connector) to the
driver's seat wire harness 2P connector (with
power seat) or driver's seat position sensor
subharness 2P connector (without power seat).
10. Disconnect both seat belt tensioner 2P connectors
from the side wire harness 2P connectors (A).
A
A
(cont'd)
23-295