Honda 2004 Odyssey Service Manual page 2173

SRS
DTC Troubleshooting (cont'd)
'02 Model
DTC 1-5: Short to Ground in Driver's Airbag
Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's airbag 4P connector from
the cable reel 4P connector (A).
5. Connect the special tool (2
cable reel 4P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
23-108
A
07XAZ-SZ30100
07SAZ-TB4011A
connectors) to the
8. Read the DTC (see page 23-35).
Is DT C 1-5 indicated?
YES Go to step 9.
NO Short to ground in the driver's airbag inflator;
replace the driver's airbag (see page 23-368).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's airbag 4P
connector (A) from the SRS main harness 4P
connector (B).
B
A
11. Disconnect both seat belt tensioner 2P connectors
(A) from the side wire harness 2P connectors (B).
A
B