Honda 2004 Odyssey Service Manual page 2332

14. Turn the ignition switch OFF.
15. Connect the special tool (jumper connector) to the
engine compartment right wire harness 2P
connector (A).
07SAZ-TB4011A
16. Check resistance between the No. 16 and No. 28
terminals of SRS unit connector A (28P). There
should be 1 or less.
SRS UNIT CONNECTOR A (28P)
Wire side of female terminals
Is the resistance as specif ied?
YES Faulty right front impact sensor or SRS unit.
Replace the right front impact sensor; if the
problem is still present, replace the SRS unit (see
page 23-384).
NO Go to step 23.
17. Disconnect the SRS main harness 28P connector
(A) from SRS floor harness connector C851.
A
18. Check resistance between the No. 16 and No. 28
terminals of the SRS main harness 28P connector.
There should be an open circuit, or at least 1 M .
07YAZ-S3AA100
BRN
GRN
YES
SRS floor harness.
NO
harness or SRS main harness; replace the faulty
harness.
A
SRS MAIN HARNESS 28P CONNECTOR
Wire side of female terminals
Is the resistance as specif ied?
Short in the SRS floor harness; replace the
Short in the engine compartment right wire
C851
BRN
GRN
(cont'd)
23-267