Honda 2004 Odyssey Service Manual page 2385

SRS
DTC Troubleshooting (cont'd)
'03-04 Models
DTC 91-1x (91-10 to 91-19, 91-1A to 91-1F):
Open in SRS Indicator Circuit
NOTE : If the SRS indicator does not come on, go to
'' The SRS Indicator Does Not Come On '' in the
symptom troubleshooting.
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect SRS unit connector A (28P) from the
SRS unit.
A
23-320
5. Remove the gauge assembly (see page 22-100).
Disconnect gauge assembly connector C (16P) from
the gauge assembly.
6. Check resistance between the No. 19 terminal of
SRS unit connector A (28P) and the No. 9 terminal
of gauge assembly connector C (16P). There should
be 0 1.0 .
SRS UNIT CONNECTOR A (28P)
BLU
Wire side of female terminals
Is the resistance as specif ied?
YES Go to step 11.
NO Go to step 7.
C
GAUGE ASSEMBLY
CONNECTOR C (16P)
BLU