Honda 2004 Odyssey Service Manual page 2146

6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-35).
Is DT C 2-5 indicated?
YES Go to step 9.
NO Short to ground in the front passenger's
airbag inflator; replace the front passenger's airbag
(see page 23-370).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the driver's airbag 2P connector (A) and
both seat belt tensioner 2P connectors (B), and
disconnect the special tool from the SRS main
harness 2P connector.
A
11. Disconnect the SRS main harness 18P connector
(A) from the SRS unit.
A
12. Check resistance between the No. 10 terminal of
the SRS main harness 18P connector and body
ground, and between the No. 14 terminal and body
ground. There should be an open circuit, or at least
1 M .
SRS MAIN HARNESS 18P CONNECTOR
B
Is the resistance as specif ied?
YES Faulty SRS unit; replace the SRS unit (see
page 23-382).
NO Short to ground in the SRS main harness;
replace the SRS main harness.
Wire side of female terminals
23-81