Honda 2004 Odyssey Service Manual page 2216

7. Unbuckle the front passenger's seat belt.
• Check resistance between the No. 1 and No. 2
terminals of the front passenger's seat belt
buckle switch 3P connector. There should be
0 1 .
• Check resistance between the No. 1 and No. 3
terminals of the same connector. There should
be an open circuit, or at least 1 M .
FRONT PASSENGER'S SEAT BELT
BUCKLE SWITCH 3P CONNECTOR
BLK
Terminal side of male terminals
BLK
Terminal side of male terminals
Is the resistance as specif ied?
YES Go to step 8.
NO Replace the front passenger's seat belt buckle
assembly, and clear the DTC.
RED/BLU
BLU/RED
8. Check resistance between the No. 1 terminal of the
right side wire harness 3P connector and body
ground. There should be 0 1
RIGHT SIDE WIRE HARNESS 3P CONNECTOR
BLK
Wire side of female terminals
Is the resistance as specif ied?
YES Go to step 9.
NO Open in the right side wire harness or poor
ground connection at G581. If G581 is OK, replace
the right side wire harness.
9. Disconnect the negative cable from the battery.
10. Disconnect SRS unit connector C (8P) from the SRS
unit.
.
C
(cont'd)
23-151