Honda 2004 Odyssey Service Manual page 2318

'03-04 Models
DTC 32-1x (32-10 to 32-19, 32-1A to 32-1F):
Open or Increased Resistance in Front
Passenger's Side Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the right side wire harness 2P
connector (A) from the front passenger's side
airbag.
07SAZ-TB4011A
5. Connect the special tool (2
right side wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
A
07XAZ-S1A0200
connector) to the
8. Read the DTC (see page 23-38).
Is DT C 32-1x indicated?
YES Go to step 9.
NO Open or increased resistance in the front
passenger's side airbag inflator, replace the front
passenger's side airbag (see page 23-372).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect both seat belt tensioner 2P connectors
from the side wire harness (A).
11. Disconnect SRS unit connector B (28P) from the
SRS unit. Do not disconnect the special tool
from the right side wire harness 2P connector.
A
B
(cont'd)
23-253