Table of Contents
Advertisement
'02 Model
DTC 5-1, 5-2, 5-4, 5-8, 6-3, 6-4, 6-7, 6-8, 7-1,
7-2, 7-3, 8-1, 8-2, 8-3, 8-4, 8-5, 8-6, 9-1, 9-2:
Internal Failure of the SRS Unit
NOTE: Before troubleshooting any of these DTCs, check
the battery/system voltage. If the voltage is low, repair
the charging system or replace the battery before
troubleshooting the SRS. If the battery/system voltage
is now OK, ask the customer if the battery ever went
dead.
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES
Replace the SRS unit (see page 23-382).
NO
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
'02 Model
DTC 10-1, 10-2, 10-3, 10-4, 10-5, 10-6, 10-7:
Airbags, Side Airbags and/or Seat Belt
Tensioners Deployed
The SRS unit must be replaced after any airbags and/or
tensioners have deployed (see page 23-382).
23-143
23-143
Advertisement
Chapters
Table of Contents
Troubleshooting
