Honda 2004 Odyssey Service Manual page 2247

SRS
DTC Troubleshooting (cont'd)
7. Check resistance between the No. 8 terminal of
SRS unit connector B (18P) and body ground. There
should be an open circuit, or at least 1 M .
SRS UNIT CONNECTOR B (18P)
Wire side of female terminals
Is the resistance as specif ied?
YES Go to step 8.
NO Go to step 9.
8. Check resistance between the No. 8 and No. 15
terminals of SRS unit connector B (18P). There
should be an open circuit, or at least 1 M .
SRS UNIT CONNECTOR B (18P)
Wire side of female terminals
Is the resistance as specif ied?
YES Faulty driver's side impact sensor or SRS
unit; replace the driver's side impact sensor (see
page 23-385). If the problem is still present, replace
the SRS unit (see page 23-382).
NO Go to step 11.
23-182
9. Disconnect the SRS floor subharness 28P
connector (A) from the SRS floor harness 28P
connector C852.
C852
A
10. Check resistance between the No. 18 terminal of
the SRS floor subharness 28P connector and body
ground. There should be an open circuit, or at least
1 M .
SRS FLOOR SUBHARNESS 28P CONNECTOR
Wire side of female terminals
Is the resistance as specif ied?
YES Short to ground in the SRS floor harness;
replace the SRS floor harness.
NO Short to ground in the SRS floor subharness
or left side wire harness; replace the faulty
harness.