Honda 2004 Odyssey Service Manual page 2328

14. Turn the ignition switch OFF.
15. Connect the special tool (jumper connector) to the
engine compartment left wire harness 2P
connector (A).
A
07YAZ-S3AA100
16. Check resistance between the No. 15 and No. 27
terminals of SRS unit connector A (28P). There
should be 1 or less.
SRS UNIT CONNECTOR A (28P)
Wire side of female terminals
Is the resistance as specif ied?
YES Faulty left front impact sensor or SRS unit.
Replace the left front impact sensor; if the problem
is still present, replace the SRS unit (see page 23-
384).
NO Go to step 23.
07SAZ-TB4011A
BRN/BLK
RED
17. Disconnect the SRS floor harness 28P connector (A)
from SRS main harness connector C851.
A
18. Check resistance between the No. 15 and No. 27
terminals of the SRS unit connector A (28P). There
should be an open circuit, or at least 1 M .
SRS UNIT CONNECTOR A (28P)
Wire side of female terminals
Is the resistance as specif ied?
YES Short in the left engine compartment wire
harness or SRS main harness; replace the faulty
harness.
NO Short in the SRS floor harness; replace the
SRS floor harness.
C851
BRN/BLK
RED
(cont'd)
23-263