Honda 2004 Odyssey Service Manual page 2323

SRS
DTC Troubleshooting (cont'd)
12. Reconnect the battery negative cable.
13. Disconnect the SRS inflator simulator from SRS
simulator lead E.
14. Turn the ignition switch ON (II).
15. Check for voltage between each terminal of SRS
simulator lead E and body ground. There should be
0.5 V or less.
RIGHT SIDE WIRE HARNESS
2P CONNECTOR
07XAZ-S1A0200
Is the voltage as specif ied?
YES Faulty SRS unit; replace the SRS unit (see
page 23-384).
NO Go to step 16.
23-258
16. Turn the ignition switch OFF.
17. Disconnect the SRS floor harness 28P connector (A)
from SRS floor subharness C852.
C852
18. Turn the ignition switch ON (II).
19. Check for voltage between the No. 23 terminal of
the SRS floor harness 28P connector and body
ground, and between the No. 24 terminal and body
ground. There should be 0.5 V or less.
SRS FLOOR HARNESS 28P CONNECTOR
RED
Terminal side of male terminals
Is the voltage as specif ied?
YES Short to power in the SRS floor subharness
or right side wire harness; replace the faulty
harness.
NO Short to power in the SRS floor harness;
replace the SRS floor harness.
A
RED/YEL