Honda 2004 Odyssey Service Manual page 2222

14. Turn the ignition switch OFF.
15. Connect the special tool (jumper connector) to the
left engine compartment wire harness 2P
connector (A).
07SAZ-TB4011A
16. Check resistance between the No. 10 and No. 11
terminals of SRS unit connector A (18P). There
should be 1 or less.
SRS UNIT CONNECTOR A (18P)
Wire side of female terminals
Is the resistance as specif ied?
YES Faulty left front sensor or SRS unit. Replace
the left front sensor; if the problem is still present,
replace the SRS unit (see page 23-382).
NO Go to step 23.
17. Disconnect the SRS main harness 28P connector
A
18. Check resistance between the No. 12 and No. 27
07YAZ-S3AA100
(A) from the SRS floor harness 28P connector C851.
C851
A
terminals of the SRS main harness 28P connector.
There should be an open circuit, or at least 1 M .
SRS MAIN HARNESS 28P CONNECTOR
Wire side of female terminals
Is the resistance as specif ied?
YES Short in the SRS floor harness; replace the
SRS floor harness.
NO Short in the left engine compartment wire
harness or SRS main harness; replace the faulty
harness.
(cont'd)
23-157