Honda 2004 Odyssey Service Manual page 2286

Hide thumbs Also See for 2004 Odyssey:
Table of Contents

Advertisement

'03-04 Models
DTC 21-1x (21-10 to 21-19, 21-1A to 21-1F):
Open or Increased Resistance in Driver's Seat
Belt Tensioner
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead C 07TAZ-SZ5011A
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES
Go to step 3.
NO
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's seat belt tensioner 2P
connector from the left side wire harness (A).
07TAZ-SZ5011A
5. Connect the special tool (2
side wire harness 2P connector.
A
07SAZ-TB4011A
connector) to the left
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-38).
Is DT C 21-1x indicated?
YES
Go to step 9.
NO
Open or increased resistance in the driver's
seat belt tensioner; replace the driver's seat belt
(see page 23-4).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the SRS main harness 2P connector
C551 from the left side wire harness 2P connector
(A).
A
07SAZ-TB4011A
11. Connect the special tool (2
main harness 2P connector.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is DT C 21-1x indicated?
YES
Go to step 15.
NO
Open or increased resistance in the left side
wire harness; replace the left side wire harness.
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
C551
07TAZ-SZ5011A
connector) to the SRS
(cont'd)
23-221

Advertisement

Table of Contents
loading

Table of Contents