Honda 2004 Odyssey Service Manual page 2271

SRS
DTC Troubleshooting (cont'd)
15. Disconnect SRS unit connector A (28P) from the
SRS unit.
16. Connect the special tool (070AZ-SAA0100) to the
No. 7 and No. 8 terminals or the No. 1 and No. 2
terminals of SRS unit connector A (28P) (see page
23-26).
23-206
17. Check resistance between the No. 9 and No. 10
terminals of the SRS floor harness 28P connector
C851, and between the No. 3 and No. 4 terminals.
There should be an open circuit, or at least 1 M .
SRS FLOOR HARNESS 28P CONNECTOR C851
A
GRN/YEL
Is the resistance as specif ied?
YES Faulty SRS unit; replace the SRS unit (see
page 23-384).
NO Replace the SRS floor harness.
GRN/WHT GRN
Terminal side of male terminals
GRN/
BLK