Honda 2004 Odyssey Service Manual page 2159

SRS
DTC Troubleshooting (cont'd)
'99-01 Models
DTC 4-4: Short to Power in Front Passenger's
Seat Belt Tensioner
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's seat belt
tensioner 2P connector from the right side wire
harness 2P connector (A).
07TAZ-SZ5011A
07SAZ-TB4011A
5. Connect the special tool (2
right side wire harness 2P connector.
23-94
A
connector) to the
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-35).
Is DT C 4-4 indicated?
YES Go to step 9.
NO Short to power in the front passenger's seat
belt tensioner; replace the front passenger's seat
belt (see page 23-4).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the SRS main harness 2P
connector C581 from the right side wire harness 2P
connector (A).
A
11. Connect the special tool (2
main harness 2P connector.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is DT C 4-4 indicated?
YES Go to step 15.
NO Short to power in the right side wire harness;
replace the right side wire harness.
C581
07TAZ-SZ5011A
07SAZ-TB4011A
connector) to the SRS