Table of Contents
Advertisement
SRS
DTC Troubleshooting (cont'd)
'02 Model
DTC 14-3:
No Signal from the Front
Passenger's Side Impact Sensor
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead H 07YAZ-S3AA100
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES
Go to step 3.
NO
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Check the connection between the right side wire
harness 2P connector and the front passenger's
side impact sensor.
Is the connection OK ?
YES
Go to step 5.
NO
Poor contact between the right side wire
harness 2P connector and the front passenger's
side impact sensor; replace the front passenger's
side impact sensor (see page 23-385).
23-184
5. Disconnect the driver's side airbag and front
passenger's side airbag 2P connectors (A).
A
A
6. Disconnect the right side wire harness 2P
connector (A) from the front passenger's side
impact sensor (B).
07SAZ-TB4011A
7. Connect the special tool (jumper connector) to the
right side wire harness 2P connector.
B
A
07YAZ-S3AA100
Advertisement
Chapters
Table of Contents
Troubleshooting
