Honda 2004 Odyssey Service Manual page 2211

SRS
DTC Troubleshooting (cont'd)
7. Unbuckle the driver's seat belt.
• Check resistance between the No. 1 and No. 2
terminals of the driver's seat belt buckle switch
3P connector. There should be 0 1
• Check resistance between the No. 1 and No. 3
terminals of the same connector. There should
be an open circuit, or at least 1 M .
DRIVER'S SEAT BELT BUCKLE SWITCH
3P CONNECTOR
BLK
Terminal side of male terminals
BLK
Terminal side of male terminals
Is the resistance as specif ied?
YES Go to step 8.
NO Replace the driver's seat belt buckle assembly,
and clear the DTC.
23-146
.
RED/BLU
BLU/RED
8. Check resistance between the No. 1 terminal of the
left side wire harness connector and body ground.
There should be 0 1
LEFT SIDE WIRE HARNESS 3P CONNECTOR
Wire side of female terminals
Is the resistance as specif ied?
YES Go to step 9.
NO Open in the left side wire harness or poor
ground connection at G551. If G551 is OK, replace
the left side wire harness.
9. Disconnect the negative cable from the battery.
10. Disconnect SRS unit connector C (8P) from the SRS
unit, dashboard harness connector C (16P) from the
gauge assembly, and the driver's multiplex control
unit from the driver's under-dash fuse/relay box.
.
BLK
C