Honda 2004 Odyssey Service Manual page 2176

'02 Model
DTC 2-1: Open or Increased Resistance in
Front Passenger's Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's airbag 4P
connector from the SRS main harness 4P
connector (A).
A
07XAZ-SZ30100
07SAZ-TB4011A
5. Connect the special tool (2
SRS main harness 4P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
connectors) to the
8. Read the DTC (see page 23-35).
Is DT C 2-1 indicated?
YES Go to step 9.
NO Open or increased resistance in the front
passenger's airbag inflator; replace the front
passenger's airbag (see page 23-370).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the driver's airbag 4P connector (A)
from the cable reel 4P connector (B).
11. Disconnect both seat belt tensioner 2P connectors
(A) from the side wire harness 2P connectors (B).
B
A
A
B
(cont'd)
23-111