Honda 2004 Odyssey Service Manual page 2265

SRS
DTC Troubleshooting (cont'd)
35. Turn the ignition switch OFF.
36. Disconnect OPDS unit harness connector D (8P)
from the OPDS unit (A).
37. Turn the ignition switch ON (II).
Does the side airbag cutof f indicator come on?
YES Go to step 38.
NO Faulty OPDS unit; replace the OPDS unit.
38. Turn the ignition switch OFF.
39. Disconnect gauge assembly connector A (14P)
from the gauge assembly (see page 22-100).
23-200
40. Check resistance between the No. 4 terminal of
A
D
A
gauge assembly connector A (14P) and body
ground. There should an open circuit, or at least
1 M .
GAUGE ASSEMBLY CONNECTOR A (14P)
GRN
Wire side of female terminals
Is the resistance as specif ied?
YES Short to ground in the side airbag cutoff
indicator circuit; replace the gauge assembly.
NO Short to ground in the dashboard wire
harness A, right side wire harness or OPDS unit
harness; replace the faulty harness.