Honda 2004 Odyssey Service Manual page 2354

'03-04 Models
DTC 62-1x (62-10 to 62-19, 62-1A to 62-1F):
Open in Front Passenger's Seat Belt Buckle
Switch
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), then buckle and
unbuckle the front passenger's seat belt several
times.
3. Read the DTC (see page 23-38).
Is DT C 62-1x indicated?
YES Go to step 4.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
4. Turn the ignition switch OFF.
5. Disconnect the front passenger's seat belt buckle
switch 3P connector (A).
6. Buckle the front passenger's seat belt.
A
• Check resistance between the No. 1 and No. 3
terminals of the front passenger's seat belt
buckle switch 3P connector. There should be
0 1 .
• Check resistance between the No. 1 and No. 2
terminals of the same connector. There should
be an open circuit, or at least 1 M .
FRONT PASSENGER'S SEAT BELT
BUCKLE SWITCH 3P CONNECTOR
BLK
Terminal side of male terminals
BLK GRY
Terminal side of male terminals
Is the resistance as specif ied?
YES Go to step 7.
NO Replace the front passenger's seat belt buckle
assembly, then clear the DTC.
BLU
(cont'd)
23-289