Honda 2004 Odyssey Service Manual page 2283

SRS
DTC Troubleshooting (cont'd)
14. Check for voltage between each terminal of SRS
simulator lead F and body ground. There should be
0.5 V or less.
SRS
MAIN HARNESS
4P CONNECTOR
07XAZ-SZ30100
Is the voltage as specif ied?
YES Faulty SRS unit; replace the SRS unit (see
page 23-384).
NO Go to step 15.
15. Turn the ignition switch OFF.
16. Disconnect the SRS floor harness 28P connector (A)
from SRS main harness connector C851.
A
17. Turn the ignition switch ON (II).
23-218
18. Check for voltage between the No. 7 terminal of the
SRS floor harness 28P connector and body ground,
the No. 8 terminal and body ground, the No. 1
terminal and body ground, and the No. 2 terminal
and body ground, There should be 0.5 V or less.
WHT
Is the voltage as specif ied?
YES
replace the SRS main harness.
NO Short to power in the SRS floor harness;
replace the SRS floor harness.
C851
SRS FLOOR HARNESS 28P CONNECTOR
RED/YEL BLU/YEL
Terminal side of male terminals
Short to power in the SRS main harness;
YEL