Honda 2004 Odyssey Service Manual page 2135

SRS
DTC Troubleshooting (cont'd)
'99-01 Models
DTC 1-3: Short to Another Wire or Decreased
Resistance in Driver's Airbag Inflator
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's airbag 2P connector from
the cable reel 2P connector (A).
5. Connect the special tool (2
cable reel 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
23-70
A
07TAZ-SZ5011A
07SAZ-TB4011A
connector) to the
8. Read the DTC (see page 23-35).
Is DT C 1-3 indicated?
YES Go to step 9.
NO Short in the driver's airbag inflator; replace
the driver's airbag (see page 23-368).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the cable reel 2P connector from the
SRS main harness 2P connector (A).
07SAZ-TB4011A
11. Connect the special tool (2
main harness 2P connector.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is DT C 1-3 indicated?
YES Go to step 15.
NO Short in the cable reel; replace the cable reel
(see page 23-376).
A
07TAZ-SZ5011A
connector) to the SRS