Honda 2004 Odyssey Service Manual page 2229

SRS
DTC Troubleshooting (cont'd)
11. Disconnect SRS unit connector B (18P) from the
SRS unit. Do not disconnect the special tool from
the left side wire harness 2P connector.
12. Check resistance between the No. 6 and No. 17
terminals of SRS unit connector B (18P). There
should be 2.0 3.0
SRS UNIT CONNECTOR B (18P)
Wire side of female terminals
Is the resistance as specif ied?
YES Faulty SRS unit or poor contact at SRS unit
connector B (18P) and the SRS unit; check the
connection; if the connection is OK, replace the
SRS unit (see page 23-382).
NO Go to step 13.
23-164
B
.
13. Disconnect the SRS floor subharness 28P
connector (A) from the SRS floor harness 28P
connector C852.
C852
A
14. Check resistance between the No. 21 and No. 22
terminals of the SRS floor subharness 28P
connector. There should be 2.0 3.0
SRS FLOOR SUBHARNESS 28P CONNECTOR
Wire side of female terminals
Is the resistance as specif ied?
YES Open or increased resistance in the SRS
floor harness; replace the SRS floor harness.
NO Open or increased resistance in the SRS floor
subharness or left side wire harness; replace the
faulty harness.
.