Honda 2004 Odyssey Service Manual page 2282

'03-04 Models
DTC 12-8x (12-80 to 12-89, 12-8A to 12-8F):
Short to Power in Front Passenger's Airbag
First Inflator
DTC 12-Ax (12-A0 to 12-A9, 12-AA to 12-AF):
Short to Power in Front Passenger's Airbag
Second Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's airbag 4P
connector from the dashboard wire harness (A).
A
07XAZ-SZ30100
07SAZ-TB4011A
5. Connect the special tool (2
SRS main harness 4P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-38).
Is DT C 12-8x or 12-Ax indicated?
YES Go to step 9.
NO Short to power in the front passenger's airbag
first or second inflator; replace the front passenger's
airbag (see page 23-370).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect SRS unit connector A (28P) from the
SRS unit.
A
11. Reconnect the battery negative cable.
12. Disconnect the SRS inflator simulator from SRS
simulator lead F.
13. Turn the ignition switch ON (II).
connectors) to the
(cont'd)
23-217