Examples - Planet GSD-800S User Manual

IP Mode
Syntax:
IP Mode [enable|disable]
Description:
Activate or deactivate the IP configuration.
[enable|disable]: Enable/disable IP (default: Show IP mode).

3.4 Examples

3.4.1 VLAN configuration
This example shows how to configure two VLANs with the following setup on at GSD-
800S:
● VID 1 spans ports 2-8 and VID 2 spans ports 1-3, so port 2 and 3 are members
of both VLANs.
● Port 1 is the access port for VID 2, so PVID of port 1 must be set to 2.
● Port 2 is the trunk port for VID 1 and VID 2, so the PVID of port 2 must be set
to none and port 2 must be set to accept tagged frames only.
● Port 3 is the hybrid port for VID 1 and VID 2, where VID 1 is the untagged
VLAN, so PVID must be set to 1.
● Ports 4-8 are access ports for VID 1.
The following CLI session does the above setup provided that the initial configuration is
the default configuration:
>vlan
VLAN>delete 1
VLAN>add 1 2-8
VLAN>add 2 1-3
VLAN>pvid 1 2
VLAN>pvid 2 none
VLAN>frame type 2 tagged
VLAN>conf
VLAN Configuration:
Port Aware PVID
1: disabled 2
Frame Type
All
23