Typical Vlan Application - Planet WGSW-52040 Configuration Manual

20.1.3 Typical VLAN Application

Scenario:
VLAN2
PC
PC
VLAN2
The existing LAN is required to be partitioned to 3 VLANs due to security and application
requirements. The three VLANs are VLAN2, VLAN100 and VLAN200. Those three VLANs are
cross two different location A and B. One switch is placed in each site, and cross-location
requirement can be met if VLAN traffic can be transferred between the two switches.
Configuration Item
VLAN2
VLAN100
VLAN200
Trunk port
Connect the Trunk ports of both switches for a Trunk link to convey the cross-switch VLAN
traffic; connect all network devices to the other ports of corresponding VLANs.
In this example, port 1 and port 12 are spared and can be used for management port or for
other purposes.
The configuration steps are listed below:
VLAN100
PC Workstation Workstation
Trunk Link
PC
Workstation VLAN100
Figure 20-2: Typical VLAN Application Topology
Configuration description
Site A and site B switch port 2-4.
Site A and site B switch port 5-7.
Site A and site B switch port 8-10.
Site A and site B switch port 11.
PC
Switch A
Switch B
PC
Workstation
20-77
VLAN200
PC
PC
VLAN200