Set Partition Home - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 2 MMB CLI (Command Line Interface) Operations
- smtp address: REMCS notification mail server
Remarks
- To change the SMTP address with this command, you need to also change the SMTP server settings from
the REMCS environment setup window. Moreover, before making the default REMCS settings, you need to
set the routing with this command.
- <gateway address> and <SMTP address> settings are not required for a P-P connection to REMCS. In such
cases, set <gateway address> and <SMTP address> to 0.0.0.0.
- To disable the settings made with this command, set <ip address> to 0.0.0.0. You can use any values for the
other parameters. However, their recommended setting is also 0.0.0.0.
Privileges: Administrator or CE
(1) Syntax
set maintenance_ip <ip address> <netmask> <gateway address> ¥
<smtp address>
¥: Indicates that the line is not broken.
(2) Options
None
(3) Usage example
Example: Setting the following IP address for the maintenance port
- IP address: 192.168.1.10
- Subnet mask: 255.255.255.0
- Gateway: 192.168.1.1
- REMCS notification mail server: 172.128.1.2
# set maintenance_ip 192.168.1.10 255.255.255.0 192.168.1.1 172.128.1.2
(4) Messages
The following messages appear for this CLI command.
For details on the messages, see the PRIMEQUEST 1000 Series Message Reference (C122-E111EN).
The specified IP address is invalid.
The specified netmask is invalid.
The specified gateway address is invalid.
The specified smtp address is invalid.
Unable to execute this command on a standby MMB.
2.2.22

set partition home

The set partition home command sets the Home SB in the specified partition.
244 C122-E110-10EN