Configure Memory] Menu; Figure 5.41 Example Of Display Of The [Configure Memory] Menu - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 5 UEFI Menu Operations
4. To save the changes to settings and exit this menu, select [Save Changes], and press the [Enter] key.
5. To exit this menu without saving the changes to settings, select [Back to Previous Page] and press the [Enter]
key.
5.5.6

[Configure Memory] menu

You can change the settings of the DIMM Self Refresh function (*1) and DDDC function (*2) from the [Configure
Memory] menu.
*1 : This enhanced function refreshes the DIMM automatically when the C-state becomes C3 or C6 on all cores
containing the Intel Xeon processor E7 in one socket.
*2 : DDDC stands for Double Device Data Correction. When a memory error is detected, this function continues
the system by disabling the faulty DRAM chip on the DIMM and replacing it with a spare DRAM chip.
The PRIMEQUEST 1800E2 displays this menu.
The changes made to settings in this menu will take effect after the system reset.

FIGURE 5.41 Example of display of the [Configure Memory] menu

The following example shows the screen display immediately after the start of the [Configure Memory] menu.
(1) Page information display area
This area displays [Configure Memory].
(2) Menu selection area
This area displays the menu outlined in TABLE 5.32 Displayed contents of menu selection
428
area.
C122-E110-10EN