Fujitsu PRIMEQUEST 1000 Series Tool Reference page 377

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 4 PSA CLI (Command Line Interface) Operations
- If multiple disk management commands are executed at the same time, they may terminate abnormally.
Confirm that there is no other instance of the disk management command being executed before executing
the command.
- After completing hot maintenance of a GDS hard disk in Linux, manually execute the following PSA
command.
/opt/FJSVpsa/sh/force_search.sh -a
(1) Syntax
- In Linux
/opt/FJSVpsa/bin/diskctrl {-l|-e|-i|-o|-c} {Devicename|
iocx/slotno}
- In Windows
diskctrl {-l|-i|-o} {diskno| \\device\scsiportno\slotno}
(2) Options
{-l|-e|-i|-o|-c}
- l: Status display
This option displays a list of HDDs recognized by the operating system.
- e: Disk rotation stop instruction
This option stops the rotation of the HDD specified in [Devicename] or [iocx/slotno]. Then, it turns on the
Fault LED.
- i: Location display
This option causes the Fault LED to blink to indicate the location of the HDD specified in [Devicename], or
the SGPIO controller specified in [iocx/slotno].
- o: Location turn-off
This option turns off the Fault LED that indicates the location of the HDD specified in [Devicename] or the
SGPIO controller specified in [iocx/slotno].
- c: Fault LED turn-off instruction
This option turns off the Fault LED that indicates the location of the SGPIO controller specified in [iocx/
slotno].
Remarks
- How to specify the target in Linux
To operate an HDD, specify its logical device name or slot number for an SGPIO controller. Before specifying
a logical device name, confirm that it exists in the operating system by using the status display (-l) option.
- Devicename: Specify a logical device name in the operating system.
Example: /dev/sda
- iocx/slotno: Specify the IOC number of an SGPIO controller and a disk slot number.
Example: ioc0/1 specifies slot 1 of ioc0.
- How to specify the target in Windows
345 C122-E110-10EN