Setting Items In The [System Setup] Window; Setting Items In The [System Power Control] Window; Table A.4 Setting Items In The [System Setup] Window; Table A.5 Setting Items In The [System Power Control] Window - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
APPENDIX A Lists of Settings
A.1.4

Setting items in the [System Setup] window

This section lists the defaults and specifiable values of the setting items in the [System Setup] window.

TABLE A.4 Setting items in the [System Setup] window

Setting item
Power Feed Mode Single
Power Restoration Restore
Policy
Shutdown Delay 5 seconds
after UPS detected
AC Failure
Partition Power On 0 seconds
Delay
Altitude Altitude <= 500 m
PSU Redundancy Non-redundant (If [Power
Mode Feed Mode] is Single)
Reserved SB Force 10 minutes
Power Off Wait
A.1.5

Setting items in the [System Power Control] window

This section lists the defaults and specifiable values of the setting items in the [System Power Control] window.

TABLE A.5 Setting items in the [System Power Control] window

Setting item
System Power None
Control
Default Specifiable values
- Single
- Dual
- Always off
- Always on
- Restore
- Schedule Sync
0 to 9999 seconds
0 to 9999 seconds
- Altitude < = 500 m
- 500 m < Altitude <
= 1000 m
- 1000 m < Altitude <
= 1500 m
- 1500 m < Altitude
- Redundant
- Non-redundant
0 to 99 minutes
Default Specifiable values
- Power On all
partition(s)
- Power Off all
partition(s) (all
partitions(s) will be
517
Remarks
The altitude specifications include an
allowable margin of error of +/-100
m.
If [Power Feed Mode] is Dual,
Redundant is the fixed value.
Remarks
C122-E110-10EN