Set Active_Mmb - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 2 MMB CLI (Command Line Interface) Operations
Are you sure to continue removing IOB#1A from Partition#2? [Y/N] Y
Removing IOB#1A from Partition#2 has been completed successfully.
#
(4) Messages
The following messages appear for this CLI command.
For details on the messages, see the PRIMEQUEST 1000 Series Message Reference (C122-E111EN).
Are you sure you want to remove %s from Partition#%d? [Y/N]:
Removing %s from Partition#%d has been completed successfully.
The specified partition number is invalid.
The specified [SB|IOB|GSPB] number is invalid.
Partition#x does not include the [SB#x|IOB#x[A|B]|IOB-[A|B]|GSPB#x[A|B]|GSPB-[A|B]].
Unable to remove the specified [SB#x|IOB#x[A|B]|IOB-[A|B]|GSPB#x[A|B]|GSPB-[A|B]] from the
partition while the partition is running.
Unable to execute this command on a standby MMB.
The specified parameter is invalid.
Unable to execute this command because the system is under maintenance.
Unable to execute this command because the Partition#x is under maintenance.
Parameter missing
Failed to execute remove partition command.
Failed to execute %s command.
The specified command is not supported.(error=[%s])
The parameter [IOB | GSPB] is not supported.
2.2.10

set active_mmb

The set active_mmb command switches the active MMB by resetting the active MMB.
If executed for the MMB that is already the active MMB, this command has no effect.
If issued without any parameters, the command assumes that the MMB connected to the CLI is specified as the
active MMB.
Remarks
- You can connect the standby MMB and issue this command from the standby MMB.
- The command differs from the Switch Over function of the MMB Web-UI.
Privileges: Administrator or CE
(1) Syntax
set active_mmb {0 | 1} {quiet}
236 C122-E110-10EN