Fujitsu PRIMEQUEST 1000 Series Tool Reference page 396

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 4 PSA CLI (Command Line Interface) Operations
The setting was completed
Remarks
In addition to the above messages, the CLI displays messages to confirm the settings.
(5) End status
0: Normal end
>0: Abnormal end
(6) Configuration procedure
Configure the interface for the management LAN before executing this command.
1. Specify the IP address of the management LAN interface in the PSA configuration file (/etc/opt/FJSVpsa/
usr/ipsetup.conf).
For details on setting the IP address of the management LAN interface, see 6.2.7 Setting the management
LAN IP address in the PRIMEQUEST 1000 Series Installation Manual (C122-E107EN).
Configuration example /etc/opt/FJSVpsa/usr/ipsetup.conf
[NETWORK]
ManagementIP=192.168.0.1
2. Prepare a configuration file that contains the IP addresses of the ports to open.
In the configuration file, specify the physical IP addresses of the MMBs (MMB physical IP addresses
<MMB#0/MMB#1>) that belong to any of the cluster nodes defined in PRIMECLUSTER. Alternatively,
specify the network IP address that includes the aforementioned MMB physical IP addresses, following the
line that contains "[PCL]" only. Each line in the file should contain only one entry.
Configuration example /tmp/config.txt
[PCL]
192.168.0.0/24
192.168.1.5
Remarks
A sample configuration file is available at:
/opt/FJSVpsa/sh/sample_conf_setmlanfw.txt
3. Execute setmlanfw.sh with the configuration file prepared in step 2 specified.
After you execute this command, messages to confirm the settings made in step 1 and step 2 appear. Enter
"Y" to accept the settings or "N" to edit the settings.
Then, proceed to the next process.
Execution example Specifying the configuration file prepared in step 2
# /opt/FJSVpsa/sh/setmlanfw.sh /tmp/config.txt
Management LAN IP address:
192.168.0.1
364 C122-E110-10EN