Chapter 4 Psa Cli (Command Line Interface) Operations - Fujitsu PRIMEQUEST 1000 Series Tool Reference

CHAPTER 4
This chapter describes the commands for operating PSA from the CLI
(command line interface).
PSA is a system management application that runs on the operating
system installed on each partition of the PRIMEQUEST 1800E.
PSA is provided only with the PRIMEQUEST 1800E.
In the PRIMEQUEST 1800E2, SVmco provides management
functions through PSA. For details on the CLI of SVmco, see the
SVmco manual.
4.1 Basic Operations with the CLI
4.2 Disk Management Command (diskctrl)
4.3 PSA Start/Stop Command (y30FJSVpsa)
4.4 Command for Collecting PSA Data for Investigation
(getopsa)
4.5 Filter Definition Update Commands (fltcpy, fltupdate)
352
4.6 Local Partition Number Acquisition Command (getpartid)
.............................................................................. 355
4.7 Serial Number Acquisition Command (getserialno)
356
4.8 SNMP Security Setting Command (setsnmpsec)
357
4.9 Firmware Information Acquisition Command (getfwinfo)
.............................................................................. 358
4.10 PCI Card Operation Command (fjpciswap)
4.11 Firewall Setting Command for the Management LAN
Interface (setmlanfw.sh)
4.12 PSA-MMB Communication LAN Setting Command
(setpsalan)
PSA CLI (Command Line
Interface) Operations
.................................. 342
............................................................. 351
...................................... 363
............................................................ 367
.................... 344
................ 349
....
....
....
............ 360