Configure Lan Remote Boot] Menu; Figure 5.25 Operation Screen For I/O Space Assignment; Table 5.18 Reflected Contents Of The [Configure Lan Remote Boot] Menu - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 5 UEFI Menu Operations

FIGURE 5.25 Operation screen for I/O space assignment (3)

5. To save the changes to settings and exit this menu, select [Commit Changes and Exit] and press the [Enter]
key.
To exit this menu without saving the changes to settings, select [Discard Changes and Exit] and press the
[Enter] key.
5.5.2

[Configure LAN Remote Boot] menu

You can select the network port to use for PXE boot, from the [Configure LAN Remote Boot] menu. The menu
displays the PXE-bootable network ports. After selecting a network port to use for PXE boot and specifying [Enable]
for the device, you can perform a PXE boot from the target device. No network port is enabled for PXE boot, by
default (Disabled).
The changes made to settings in this menu will take effect after the system reset. For details on set contents in this
menu, see TABLE 5.18 Reflected contents of the [Configure LAN Remote Boot]

TABLE 5.18 Reflected contents of the [Configure LAN Remote Boot] menu

Setting
UEFI (PXE/iSCSI) (*2)
Reflected contents
A boot option for PXE boot is added to [Boot Manager] menu.(*1)
Also, a network port is added to the [iSCSI Configuration] menu in
the [Device Manager] menu. (See
menu.)
405
menu.
5.5.5 [iSCSI Configuration]
C122-E110-10EN