Configure Sr-Iov] Menu; Figure 5.44 Screen For Operation To Set The Dimm Self Refresh Function - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 5 UEFI Menu Operations
Select [Disabled] to disable the DIMM Self Refresh function.
4. Press the [Enter] key.
The pop-up window closes and the results of your changes are displayed.

FIGURE 5.44 Screen for operation to set the DIMM Self Refresh function (3)

5. To save the changes to settings and exit this menu, select [Commit Changes and Exit] and press the [Enter]
key.
To exit this menu without saving the changes to settings, select [Discard Changes and Exit] and press the
[Enter] key.
5.5.7

[Configure SR-IOV] menu

SR-IOV (Single Root I/O Virtualization), which supports PCI device virtualization at the hardware level, is a
standard for high-speed virtualization (*1). From the [Configure SR-IOV] menu, the setting for using the hardware
assist function that supports SR-IOV can be changed (*2).
The changes made to settings in this menu will take effect after the system reset.
*1: This standard is effective only with the PRIMEQUEST 1800E2.
*2: On the [Configure SR-IOV] menu, the following version number is displayed. Do not change the setting.
- PRIMEQUEST 1800E Series version SA12011 or later
- PRIMEQUEST 1800E2 version SB11121 or later
431 C122-E110-10EN